Audioquest Rocket 88 Full Range Speaker Cable Pair 8 Foot Nakamichi Banana Connectors

For your kind consideration is this Audioquest Rocket 88 Bi-Wire speaker cable pair. They have been tested and pass signal clearly. The cables measure 8 feet in length and have the 72V DBS Level X noise trapping packs and are built with Nakamichi banana connectors, straight on one end and right angle on the other. Why pay $1,289.95 for a new pair of 8ft Audioquest Rocket 88 speaker cables when you can get these for a fraction of the price. when Enjoy!

From Audioquest:

Rocket 88 incorporates AudioQuest's patented Dielectric-Bias System (DBS) and replaces Long-Grain Copper with solid Perfect-Surface Copper+. DBS offers a lower noise-floor, so you can hear deeper into the nuances of your favorite music. At the same time the addition of more PSC+ offers a smoother, more relaxed, and natural sonic timbre and texture.

SOLID PERFECT-SURFACE COPPER+ (PSC+) CONDUCTORS

Solid conductors prevent electrical and magnetic strand-interaction. PSC+ Solid-Copper minimizes distortion caused by grain boundaries and maximizes linear RF Noise-Dissipation.

DOUBLE STAR-QUAD GEOMETRY

The relationship between conductors defines a cable's most basic electrical values (capacitance and inductance). However, even when those variables are kept in reasonably neutral balance, the particular geometric relationship between conductors greatly affects the sound. Star-Quad geometry is not only vastly superior to conductors run in parallel, but also to the same conductors as two twisted pairs.

DIELECTRIC-BIAS SYSTEM WITH RADIO FREQUENCY TRAP

All insulation between two or more conductors is also a dielectric whose properties will affect the integrity of the signal. When the dielectric is unbiased, dielectric-involvement (absorption and non-linear release of energy) causes different amounts of time delay (phase shift) for different frequencies and energy levels, which is a real problem for very time-sensitive multi-octave audio. The inclusion of an RF Trap (developed for AudioQuest’s Niagara Series of power products), ensures that radio-frequency noise will not be induced into the signal conductors from the DBS field elements. (DBS, US Pat #s 7,126,055 & 7,872,195 B1)

CARBON-BASED NOISE- AND CROSSTALK-DISSIPATION SYSTEM

This cable's negative conductors are covered with partially conductive Carbon-Loaded Polyethylene. This remarkable material reduces radio-frequency garbage being fed back into the amplifier. The sonic benefit is exactly the same reduction in "hash" and improved dimensionality that comes whenever RF interference is reduced in an audio circuit. In addition, a carbon layer damps interaction between positive and negative conductors, and an external Carbon-Based Noise-Dissipation System reduces external interference.

FOAMED-POLYETHYLENE INSULATION (FOR ALL POSITIVE CONDUCTORS)

Any solid material adjacent to a conductor is actually part of an imperfect circuit. Wire insulation and circuit board materials all absorb energy. Some of this energy is stored and then released as distortion. This cable, however, uses air-filled Foamed-Polyethylene Insulation on both conductors. Because air absorbs next to no energy and Polyethylene is low-loss and has a benign distortion profile, Foamed-PE, with its high air content, causes much less of the out-of-focus effect common to other materials.

*All orders may require a signature at time of delivery unless discussed prior to shipment.

*International customers will need to pay actual shipping cost if amount is greater than estimated shipping charge shown. In many cases, international shipping may be less than price shown. Please contact us with your country and postal code prior to purchase if you need a shipping quote, and we will send an offer with exact correct shipping charges.